Product Description
Servo pump pulley
Keyway style, with feather key for fixing the pulley.
Suitable for all Saginaw (rear pressure connection) servo pumps where the pulley is secured at the front with a nut.
Suitable for all big block engines without air conditioning, or with a 2 groove crankshaft pulley. For all others, there could be an offset between the crankshaft pulley and the servo pump pulley.
Power steering pulley - Saginaw with wrench
The nut is included in the bolt set: 109-1513
Here is our brand new power steering pulley for early Saginaw power steering pumps that use a lock nut to hold the pulley on the pump. These pulleys are designed to work with our 132-1002 reproduction water pump pulley and 132-1001 double groove crank pulley to ensure proper belt spacing and alignment. Forget scrounging for used and often damaged originals... we have high quality, brand new reproductions at prices that are practically off the exchange market! PLEASE NOTE: Our reproduction pulleys are stamped steel, just like the originals manufactured by Chrysler. As with all stamped steel pulleys, including Chrysler originals, the concentricity (roundness) of the pulleys may vary by 0.020 inch to 0.070 inch (up to approximately 1/16 inch). This does not affect the ability of the pulley to hold the belt over the entire power band of the engine. If you are concerned about this, we recommend switching to a fully machined pulley, such as one made from billet aluminum.
Black Saginaw Performance Style Power Steering 3 spoke pulley. 6 7/8“ outside diameter shaft 0.625” with key. Fits all B/RB Saginaw power steering pumps with keyed shaft from 1965 to approximately 1974. On Saginaw pumps, the pressure line (union) is located at the rear and near the bottom of the pump.
NOTE 1-This pulley will not work on Federal Thompson, TRW or Chrysler power steering pumps (the pressure hose is located behind the pulley, in front of the reservoir on the battery side of the pump)
2 Works on 1970 and later small block engines with the Saginaw Keyed Nuted Shaft Pump, on original Saginaw Power Steering Pump Bracket Kit, mounted low on the driver's side of the engine.
3 Works with or without factory air conditioning
4 Works with VVN-132-1001 & VVN-132-1000 crankshaft pulleys.
5 Works on Hemi engines with thin harmonic damper. Will not work on Hemi-Street vibration dampers unless the thin damper (oe 383/440) is used.
6- Works with MOP-PS001, MOP-PS004, MOP-PS008 Saginaw PS pump mount kit
7- Works with all Saginaw power steering pumps listed in the Moparshop with keyway (shuttle fixation on the input shaft)
