Product Description
Transmission Crossmember
Engineered to facilitate installing a transmission into your car when using the USCT Transmission Tunnel Perimeter Frame. Requires additional fabrication and welding.
The universal Transmission Cross-member Kit includes weld on mounting brackets, cross-member bracket, transmission mount "baskets" and adapter plates for Gen3 Hemi swaps NAG1 and HP70 transmissions. Also works to install 727, 518, 833 and the GM 4L80 and 4L60 and a variety of other transmissions into any car that has a USCT Transmission Perimeter Frame.
Short version of installation instructions:
-Bolt the adapter plate to your transmission, bolt on a transmission rubber mount, bolt that to the mount basket.
-Mock-up your drive-train in the car, set the height of the transmission (for drive-line angle - OEM was approximately 2 degrees downward towards the rear), assemble the mounting brackets to the cross-member and then clamp the USCT cross-member against the basket.
-Locate the weld-on mounting brackets against the sides of the Transmission Perimeter Frame.
-Confirm angles, center line and correct position of the drive-train. Weld the mounting brackets to the Transmission Tunnel Perimeter Frame, weld the basket to the cross-member.
