Product Description
Überllaufbehälter für den Wasserkühler
mit Funktion als Ausgleichsgefäß
Hochwertige Ausführung
Brand: Meziere Enterprises
Manufacturer's Part Number: WR100S
Part Type: Overflow and Recovery Tanks
Product Line: Meziere Recovery Tanks
Overflow Tank Material: Aluminum
Overflow Tank Finish: polished
Shape: Rectangular
Capacity: 28 oz.
Length (in): 3.000 in.
Width (in): 2.000 in.
Height (in): 10.000 in.
Vented: Yes
Recirculating: Yes
Drain Valve Included: No
Inlet Quantity: Four
Inlet Attachment: Female threads
Inlet Size: 1/8 in. NPT
Outlet Quantity: One
Outlet Attachment: Female threads
Outlet Size: 1/8 in. NPT
Overflow Tank Mounting: Bolt-in
Mounting Hardware Included: No
Quantity: Sold individually.
These Meziere recovery tanks are designed to catch overflow liquid and purge air out of your system during heat cycles.
Features include:
* 0.125 in. thick aluminum construction
* Available in blue, red, black anodized or polished finishes
* -12 AN O-ring sealing cap for filling provision
* Stainless steel fitting reaches the bottom of the tank to provide the recovery action
* 2 1/8 in. NPT female ports for easy attachment
* Threaded inserts for simple mounting
Over Flow Tank, 2 in. x 3 in. x 125 in. Rectangle, Aluminum, Two 8 AN Ports, Polished, Each
Product Description
Meziere recovery tanks are designed to catch overflow liquid and purge air out of your system during heat cycles. This enables the system to stay completely full of water and greatly reduces theamount of maintenance reqired for your cooling system.
Recovery System Info:
Keeping the system full reduces aeration and maintains pressure. As the temperature increases the water expands and pressure builds. If the system is completely full the expansion pressure will exceed the cap pressure and over flow into the recovery tank. If your pressure cap is properly located, on the low pressure side of the system, air is pushed out first. When the system cools a vacuum is created. When your radiator cap is equipped with a valve that opens under negative pressure it will draw coolant back into the system. The tube that extends to the bottom of the recovery tank transfers the coolant back to the radiator. Mount the tank as close as possible to the pressurecap. The line should be short and level, reducing restriction and the effect of gravity. If the recovery tank is kept 1/3 full (with the engine cold) every heat cycle will automatically purge more air out of the system. The opposite is true without a recovery system or with an improper pressure cap location. With every heat cycle water will be pushed out, leaving more air space. This air space can be compressed lowering the boiling point.
This part number features:
Made from 2_x3_x.125_ rectangle aluminum tube
28 ounce capacity
O-ring sealed #12AN cap for a filling provision
Supplied with a stainless fitting that reaches to the bottom of the tank to provide the _recovery_ action
The remaining 1/8 NPT port on the top is for a vent to be run to the rear of the vehicle
The bottom has a 1/8 NPT port which is factory sealed but can be used if so desired
Show quality polished
Two crosstubes are welded into the tank for mounting on a 5_ vertical center to center. There is a 1/4 through hole and a 5/16-18 thread in these tubes
